OUTPUT
CONFIGURATION ("OT.CF")
Output Configuration
is not active unless your meter has analog output capabilities. The menu
will display whether analog output is present or not.
Use Output Configuration ("OT.CF") to select the following:
* To enable or disable the analog output
* To select if the analog output is current or voltage
* To determine if the analog output is a retransmission of the
display or proportional to the error (the difference between reading and
setpoint value)
To Enable or Disable the Analog Output
1. Press the MENU button until the meter shows "OT.CF".
2. Press the /DEV
button.The meter shows one of the following:
* "O.1=D" (Analog output disabled)
* "O.1=E" (Analog output enabled) (default)
3. Press the /MAX
button to toggle between available choices.
4. Press the /DEV
button to select analog output as current/voltage or press the press
the MENU button to store your choice. The meter momentarily shows
"STRD" , followed by "OT.S.O" (Output Scale and Offset -
refer to Section 18).
To Select Analog Output as Current or Voltage
1. Press the /DEV
button. The meter shows one of the following:
* "O.2=V" (Analog output = voltage)
* "O.2=C" (Analog output = current) (default)
2. Press the /MAX
button to toggle between available choices.
3. Press the /DEV
button to select analog output/ proportional control or press the MENU
button to store your selection. The meter momentarily shows "STRD"
, followed by "OT.S.O" (Output Scale and Offset - refer to Section
18) or "P.BND" (Proportional Band - refer to Section 16).
To Select Analog Output or Proportional
Control
To determine if the meter is to transmit an analog signal out (proportional
to your display), or serve as a proportional controller (proportional
to the error = display - setpoint 1).
1. Press the /DEV
button. The meter shows one of the following:
"O.3=A" (Analog output is regular) (Default)
"O.3=P" (Analog output is proportional)
2. Press the /MAX
button to toggle between available choices.
3a. If you select O.3 to equal A, press the MENU button
to store your selection. The meter momentarily shows "STRD", followed
by "OT.S.O" (Output Scale and Offset).
3b. If you select O.3 to equal P, press the /DEV
button. The meter shows one of the following:
"O.4=D" (Proportional analog output is DIRECT ACTING)
"O.4=R" (Proportional analog output is REVERSE ACTING).
4. Press the /MAX
button to toggle between available choices.
5. Press the MENU button to store your selections. The meter
momentarily shows "STRD", followed by "P.BND" (Proportional
Band).
Additionally, if you select O.2 to equal V (Analog output to be voltage),
press the /DEV
button. The meter shows one of the following displays:
"O.5=F" (Proportional 0-10 V analog output)
"O.5=H" (Proportional 0-5 V analog output).
6. Press the /MAX
button to toggle between choices.
7. Press the MENU button to store your choices. The meter
momentarily shows "STRD", followed by "P.BND" (Proportional
Band)
|